Jump to content United States-English
» Contact HP

HP Linux imaging and printing

Print, scan and fax drivers for Linux




» About HPLIP
» Screenshots
» Release information
» Licensing information
» Get help

Install and setup

» Download instructions
» Installation instructions
» Installation wizard
» Supported printers
» System requirements
Content starts here

Troubleshooting Fullbleed (edge to edge printing) problems; All Supported OS's.

Applies To
HPLIP Version: 
Linux OS Distribution(s): 

The image you are trying to print is not printing fullbleed or edge to edge.


See steps below.


Fullbleed Troubleshooting

  1. Make sure that "Fit to Page" is Off.
  2. Make sure the image is scaled to the same size as the paper.
  3. Make sure the printer is set to fullbleed mode. This is found on the printer properties dialog or in the CUPS printer administration page.
  4. Make sure your printer is set to use the correct size of paper that you are trying to print on.
  5. Make sure the printer is set to the correct region and language.
  6. Make sure the print orientation is set correctly.